HP 8719ET Reference Manual page 147

Hardkey/Softkey Reference
Analyzer Functions
EDIT LIMIT LINE
EDIT LIST
ELECTRICAL DELAY
EMIT BEEP
END OF LABEL
END SWEEP HIGH PULSE
END SWEEP LOW PULSE
ENHANCED RESPONSE
ENTRY Off
ERASE TITLE
EXECUTE TEST
EXT SOURCE AUTO
EXT SOURCE MANUAL
EXT TRIG ON POINT
5-20
displays a table of limit segments on the LCD,
superimposed on the trace. The edit limits menu is
presented so that limits can be defined or changed. It is
not necessary for limit lines or limit testing to be on while
limits are defined.
presents the edit list menu. This is used in conjunction
with the edit subsweep menu to define or modify the
frequency sweep list. The list frequency sweep mode is
selected with the
LIST FREQ
adjusts the electrical delay to balance the phase of the
DUT. It simulates a variable length lossless transmission
line, which can be added to or removed from a receiver
input to compensate for interconnecting cables, etc. This
function is similar to the mechanical or analog "line
stretchers" of other network analyzers. Delay is annotated
in units of time with secondary labeling in distance for the
current velocity factor.
causes the instrument to beep once.
terminates the HP-GL "LB" command.
sets the TTL output on TEST SEQ BNC or the test set
interconnect to normally high with a 10 microseconds
pulse high at the end of each sweep.
sets the TTL output on TEST SEQ BNC or the test set
interconnect to normally low with a 10 µs pulse low at the
end of each sweep.
provides access to the series of menus used to perform an
enhanced response calibration.
turns the active entry off. This also removes error and
warning messages.
deletes the entire title.
runs the selected service test.
selects the auto external source mode.
selects the manual external source mode.
is similar to the trigger on sweep, but triggers each data
point in a sweep.
softkey described below.