HP 8719ET Reference Manual page 134

ADAPTER REMOVAL
ADD
ADDRESS: 8720
ADDRESS: CONTROLLER
ADDRESS: DISK
ADDRESS: P MTR/HPIB
ADJUST DISPLAY
ADJUSTMENT TESTS
ALL SEGS SWEEP
ALC ON off
ALTERNATE A and B
AMPLITUDE OFFSET
ANALOG IN Aux Input
ARBITRARY IMPEDANCE
provides access to the adapter removal menu.
displays the edit segment menu and adds a new segment
to the end of the list. The new segment is initially a
duplicate of the segment indicated by the pointer > and
selected with the
SEGMENT
sets the HP-IB address of the analyzer, using the entry
controls. There is no physical address switch to set in the
analyzer. The default HP-IB address is 16.
sets the HP-IB address the analyzer will use to
communicate with the external controller.
sets the HP-IB address the analyzer will use to
communicate with an external HP-IB disk drive.
sets the HP-IB address the analyzer will use to
communicate with the power meter used in service
routines.
presents a menu for adjusting display intensity, colors,
and accessing save and recall functions for modified LCD
color sets.
leads to the beginning of the adjustment tests. These tests
generate correction constants that are used by the
analyzer.
retrieves the full frequency list sweep.
turns the source ALC off, sets the power to maximum. May
cause a test port overload message.
measures only one input, A or B, per frequency sweep, in
order to reduce spurious signals. Thus, this mode
optimizes the dynamic range for all four S-parameter
measurements.
adds or subtracts an offset in amplitude value. This allows
limits already defined to be used for testing at a different
response level. For example, if attenuation is added to or
removed from a test setup, the limits can be offset an
equal amount. Use the entry block controls to specify the
offset.
displays a dc or low frequency ac auxiliary voltage on the
vertical axis, using the real format. An external signal
source such as a detector or function generator can be
connected to the rear panel AUXILIARY INPUT
connector.
defines the standard type to be a load, but with an
arbitrary impedance (different from system Z0).
Hardkey/Softkey Reference
Analyzer Functions
softkey.
5-7