HP 8719ET Reference Manual page 212

REQUESTED DATA NOT CURRENTLY AVAILABLE
Error Number The analyzer does not currently contain the data you have requested. For
30 example, this condition occurs when you request error term arrays and no
calibration is active.
SAVE FAILED. INSUFFICIENT MEMORY
Error Number You cannot store an instrument state in an internal register due to insufficient
151 memory. Increase the available memory by clearing one or more save/recall
registers and pressing
SEGMENT #n POWER OUTSIDE RANGE LIMIT
Information The selected power range does not support the power level of one or more
Message segments in the swept list table. This message appears when swept list mode is
not on and reports the first segment that is out of range. Change the segment
power or change the power range.
SEGMENT #n START FREQ OVERLAPS PREVIOUS SEGMENT
Information A segment entered in the swept list table caused one or more frequency
Message segments to overlap. This message appears when swept list mode is not on and
reports the first segment that is overlapping another. Change the frequency
ranges of the overlapping segments.
SELECTED SEQUENCE IS EMPTY
Error Number The sequence you attempted to run does not contain instrument commands.
124
SELF TEST #n FAILED
Service Error Internal test #n has failed. Several internal test routines are executed at
Number 112 instrument preset. The analyzer reports the first failure detected. Refer to the
service guide for troubleshooting information on internal tests and the
self-diagnose feature.
SEQUENCE ABORTED
Error Number
The sequence running was stopped prematurely when you pressed the
157
key.
SEQUENCE MAY HAVE CHANGED, CAN'T CONTINUE
Error Number When you pause a sequence, you cannot continue it if you have modified it. You
153 must start the sequence again.
, or by storing files to a disk.
Preset
Error Messages
Error Messages in Alphabetical Order
Local
6-19