HP 8719ET Reference Manual page 150

FORMAT: DOS
FORMAT: LIF
FORMAT EXT DISK
FORMAT INT DISK
FORMAT INT MEMORY
FORWARD: OPENS
FREQ OFFS MENU
FREQ OFFS on OFF
FREQUENCY
FREQUENCY BLANK
FREQUENCY: CW
FREQUENCY: SWEEP
FULL 2-PORT
FWD ISOL'N
(Label Class)
FWD MATCH
(Specify Class) specifies which standards are in the forward match class
FWD MATCH
FWD MATCH THRU
(Label Class)
FWD TRANS
(Specify Class) specifies which standards are in the forward transmission
FWD TRANS
causes subsequent disk initialization to use the DOS disk
format.
causes subsequent disk initialization to use the LIF disk
format.
FORMAT: LIF
initializes media in external drive, and formats the disk
using the selected (DOS or LIF) format.
initializes media in internal drive, and formats the disk
using the selected (DOS or LIF) format.
clears all internal save registers and associated cal data
and memory traces.
provides access to the menu for selecting an open
calibration type when the cal kit defines more than one
open standard.
leads to the frequency offset menu (Option 089 only).
switches the frequency offset mode on and off.
specifies the frequency of a calibration factor or loss value
in the power meter cal loss/sensor lists.
blanks the displayed frequency notation for security
purposes. Frequency labels cannot be restored except by
instrument preset or turning the power off and then on.
sets the LO frequency to CW mode for frequency offset.
sets the LO frequency to sweep mode for frequency offset.
provides access to the series of menus used to perform a
complete calibration for measurement of all four
S-parameters of a two-port device. This is the most
accurate calibration for measurements of two-port devices.
measures the forward isolation of the calibration
standard.
lets you enter a label for the forward match class. The
label appears during a calibration that uses this class.
in the calibration kit.
measures the forward match using a thru standard.
lets you enter a label for the forward transmission class.
The label appears during a calibration that uses this class.
class in the calibration kit.
Hardkey/Softkey Reference
Analyzer Functions
is the default setting.
5-23