HP 8719/20/22ES Specifications and Characteristics
Instrument Specifications
Table 1-38 General Information
HP 8719/20/22ES General Information
Description
System Bandwidths
IF bandwidth settings
Rear Panel
External Auxiliary Input
Connector
Range
External Trigger
Damage Level
Limit Test Output
Damage Level
Test Sequence Output
Test Set Interconnect
Measure Restart
External AM Input
High Stability Frequency
Reference Output (10 MHz)
(Option 1D5)
Frequency
Frequency Stability
(0 °C to 55 °C)
Daily aging rate (after 30 days) < 3 x 10
Yearly aging rate
Ouput
Output Impedance
1-42
Supplemental Information
6000 Hz, nom.
3700 Hz, nom.
3000 Hz, nom.
1000 Hz nom.
300 Hz, nom.
100 Hz, nom.
30 Hz, nom.
10 Hz, nom.
Female BNC
±10 V, typ.
Triggers on a positive or negative TTL transition or contact
closure to ground.
< −0.2 V; > +5.2 V, typ.
Female BNC.
< −0.2 V; > +5.2 V, typ.
Outputs a TTL signal which can be set to a TTL high pulse
(default) or low pulse at end of sweep; or a fixed TTL high or
low. If limit test is on, the end of sweep pulse occurs after the
limit test is valid. This is useful when used in conjunction with
test sequencing.
25-pin-D-sub (DB-25) female; use for external special test sets
(K36, K39, etc.)
Floating closure to restart measurement.
±1 volt into a 5 kΩ resistor, 1 kHz maximum, resulting in
approximately 2 dB/volt amplitude modulation.
10.0000 MHz, char.
±0.05 ppm, char.
−9
/day, char.
±0.5 ppm/year, char.
≥0 dBm, char.
50 Ω, nom.