HP 8719ET Reference Manual page 176

RIGHT LOWER
RIGHT UPPER
ROUND SECONDS
S PARAMETERS
S11 1-PORT
S11A
S11B
S11C
S11 REFL SHORT
S11/21 ENH. RESP
S22 1-PORT
S22/12 ENH. RESP
S22A
draws a quarter-page plot in the lower right quadrant of
the page.
draws a quarter-page plot in the upper right quadrant of
the page.
resets the seconds counter to zero in real-time clock.
presents the S-parameter menu, which is used to define
the input ports and test set direction for S-parameter
measurements.
provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 1 of an S-parameter test set or
the reflection test port of a transmission/reflection test set.
is used to enter the standard numbers for the first class
required for an S 1-port calibration. (For default cal kits,
11
this is the open.)
is used to enter the standard numbers for the second class
required for an S 1-port calibration. (For default cal kits,
11
this is the short.)
is used to enter the standard numbers for the third class
required for an S 1-port calibration. (For default kits,
11
this is the load.)
measures the short circuit TRL/LRM calibration data for
PORT 1.
provides an S11 and S21 enhanced response calibration
(forward direction). Enhanced response generates a 1-port
cal for S11 and an improved calibration over the response
cal for S21 (ES only).
provides a measurement calibration for reflection-only
measurements of one-port devices or properly terminated
two-port devices, at port 2 of an S-parameter test set or
the transmission test port of a transmission/reflection test
set.
provides an S22 and S12 enhanced response calibration
(reverse direction). Enhanced response generates a 1-port
cal for S22 and an improved calibration over the response
cal for S12. (ES only)
is used to enter the standard numbers for the first class
required for an S 1-port calibration. (For default cal kits,
22
this is the open.)
Hardkey/Softkey Reference
Analyzer Functions
5-49