Ac Power Cord Requirement; Connecting The Ac Power Cord - Christie L2K1000 Setup Manual

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories (UL)
and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug
will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert
the plug into the outlet, contact your electrician.

Connecting the AC Power Cord

This projector uses nominal input voltages of 100–240 V AC. It
is designed to work with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical shock,
do not plug into any other type of power system.
If you are not sure of the type of power being supplied, consult
your authorized dealer or service center.
Connect the projector with all peripheral equipment before turning
on the projector.
✔
Note:
•Unplug the AC power cord or turn off the MAIN ON/OFF Switch
when the projector is not in use. When the projector is in stand-
by mode, it consumes a little electric power.
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with
the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet,
contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.

AC Power Cord Requirement

For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
- 6 -
Connect the AC power cord (supplied) to
the projector.
CAUTION
The AC outlet must be near this equipment and
must be easily accessible.
AC Outlet side
For Continental Europe
To the AC Outlet.
(200–240 V AC)
GROUND
020-000409-01 Rev.1 (08-2011)