Table of Contents
Advertisement
Connecting the line cord
Warning! Failure to comply with the following could result in death or serious injury.
• Do not attempt operation if the AC supply and cord is not within the specified ratings. Use the line
cord provided with the projector, or ensure you are using a line cord, power plug, and socket that
meet the appropriate rating standards. Voltage and current requirements are listed on the license
label, located at the back of the projector.
• On power down, wait 5-10 minutes for the fans to turn OFF before unplugging the projector.
Always switch off the projector before unplugging the AC line cord.
1. Connect the projector line cord to the AC receptacle at the AC inlet of the projector.
2. Push the wire clip over the plug to retain it. This prevents the line cord from inadvertent
disconnection.
3. Plug the three-pronged plug end into a suitably rated grounded AC receptacle.
4. Switch the projector ON. The switch is located just above the AC receptacle.
Powering on the projector
After the AC Power has been switched on, the LCD display above the keypad indicates "Please wait"
and the four LED status indicators on the top cover window switch on to amber. These indicate that
the projector is changing its state from powered down to standby. The message "Standby Mode"
appears in the display when the projector has completed its initialization and is ready for power up.
The two lamp status LEDs go off to indicate that the lamps are off. The Power status LED shows
amber, indicating that the projector is in standby mode. The shutter LED displays amber, indicating
the shutter is closed. For a full description of the status indicator, see
1. Press and hold the power button on the keypad or remote for two seconds, or press twice
quickly. The lamps power on and the fans will come on.
The default settings for the projector are to perform a lens calibration after the insertion of a new
lens. If this is the first time the projector has been powered up with the lens, expect a short period
(about 15 seconds) where the lens will move slightly.
Selecting a source
1. To select and display the image for the connected source, press one of the input keys on the
remote, or on the built-in keypad.
Adjusting the image
Adjust the image settings, such as Brightness, Contrast, Gamma, Focus, Zoom etc. using the direct
keys on the remote, or on the built-in keypad.
M Series Quick Start Guide
020-101941-01 Rev. 1 (07-2015)
Installation and Setup
Status LEDs
on page 20.
12
Advertisement
Table of Contents
