Ac Power Cord Requirement; Note On The Power Cord; Connecting The Ac Power Cord - Christie L2K1500 Setup Manual

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.
AC Power Cord for the United States and Canada:
AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories
(UL) and certified by the Canadian Standard Association (CSA).
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the plug
will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to insert
the plug into the outlet, contact your electrician.

Connecting the AC Power Cord

This projector uses nominal input
voltages of 200–240 V AC. It is designed
to work with single-phase power
systems having a grounded neutral
conductor. To reduce the risk of electrical
shock, do not plug into any other type
of power system. If you are not sure
of the type of power being supplied,
consult your authorized dealer or service
center. Connect the projector with all
peripheral equipment before turning on
the projector.
✔
Note:
•Unplug the AC power cord or turn off the MAIN ON/
OFF Switch when the projector is not in use. When
the projector is in stand-by mode, it consumes a
little electric power.

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on your
projector.

AC Power Cord Requirement

1
Power cord clamp
Insert the both ends of the
power cord clamp into the
holes and tilt the clamp.
AC Outlet side
For the U.S.A. and Canada
Ground
To the AC Outlet.
(200-240 V AC)
Holes
2
Connect the AC
power cord to the
projector.
CAUTION
The AC outlet must be near this equipment and
must be easily accessible.
For Continental Europe
To the AC Outlet.
(200–240 V AC)
- 6 -
GROUND
3
Secure the power
cord connector
with the clamp.
020-000410-01 Rev.1 (05-2011)