Table of Contents
Advertisement
Chapter 7: Cabling the Networking Ports
Installing AT-QSFPSR4 or AT-QSFPLR4 Transceivers in QSFP+ Slots
118
This section contains the procedure for installing AT-QSFPSR4 or AT-
QSFPLR4 transceivers in the QSFP+ slots 17 and 21.
Please review "Guidelines to Handling SFP, SFP+, and QSFP+
Transceivers" on page 111 before performing this procedure.
To install AT-QSFPSR4 or AT-QSFPLR4 transceivers, perform the
following procedure:
1. Remove the dust cover from QSFP+ slot 17 or 21. Refer to Figure 70
on page 119.
2. Slide a QSFP+ transceiver into the slot until it clicks into place.
3. Attach fiber optic cable to the transceiver.
4. Connect the other end of the cable to a compatible QSFP+ port in
another network device.
5. Repeat this procedure to install a second QSFP+ transceiver.
Note
To remove the connector and cable from the slot, gently push on the
connector, pull on the release tab, and slide the connector from the
slot.
Advertisement
Table of Contents
