Table of Contents
Advertisement
Chapter 5: Cabling the Networking Ports
Installing AT-SP10TW1 and AT-SP10TW3 Direct Attach Cables
72
The SFP/SFP+ transceiver ports support AT-SP10TW1 and AT-SP10TW3
Direct Attach Cables. The cables are an economical way to add 10Gbps
connections over short distances. They can also be used as trunk cables
with VCStack. The AT-SP10TW1 and AT-SP10TW3 Cables come in one
and three meters, respectively, and have SFP+ transceivers on both ends.
Note
The XS900MX Switches do not support the AT-SP10TW7 Direct
Attach Cable.
To install AT-SP10TW cables, perform the following procedure:
1. Select a port for the transceiver.
1. If the port has a dust cover, remove the cover. Refer to Figure 41 on
page 70.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. To install the transceiver in a port in the top row, position the
transceiver with the Allied Telesis label facing up. To install the
transceiver in a port in the bottom row, position the transceiver with the
label facing down. Refer to Figure 44.
Figure 44. Installing AT-SP10TW Cables
4. Slide the transceiver into the port until it clicks into place.
Advertisement
Table of Contents
