Table of Contents
Advertisement
Table 4 Tape Drive
Locations
Displaying the
Library's Actuator
2
Status
When the following is displayed in the SDA, exit the menu
9
mode.
Tape Drive Number
Drive 0
Drive 1
Drive 2
Drive 3
Drive 4
Drive 5
Drive 6
This option reports the position of each of the four actuators
(horizontal, vertical, extension, gripper) in the library. You can use
this option to test for proper operation and tracking of each
actuator.
Enter the menu mode.
1
Use the
button to bypass the Configuration, Drive Control,
2
Calibration, System Test, and Robot Control menus and verify
the following is displayed in the SDA:
Quantum|ATL 7100 Series Library Operator's Guide
Chapter 2 Operating the Library
Using the Control Panel Menus
Menu:Clean
Drive n
Physical Location
top drive
second drive
third drive
fourth drive
fifth drive
sixth drive
bottom drive
Menu:
Diagnostics
41
Advertisement
Table of Contents
