Insert Steps Into A Chase - LeuchtKraft DMX-4840 Instruction Manual

4.11 Insert Steps into a Chase

LEUCHTKRAFT
6. Use the Jog wheel #3、#4 to adjust the FADE TIME and WAIT
TIME which are going to be added to the single Chase. If you do not
make any adjustments, the system will remember the last FADE
TIME or WAIT TIME.
7. Press the button MANUAL/REC all LEDs flicker for 3 times to
indicate that you have successfully programmed a step.
8. Repeat steps 2-3 to select other steps.
9. Press the button CHASE to store and exit the programming state.
10. Press the button PROGRAM for 3 seconds to exit Program
mode, the LED goes out indicating this operation.
1. Enter Program mode.
2. Press the button CHASE use jog wheel #1 to select the page
number, choose the programming chase.
3. Press the button 1-20 to select the chase number.
DMX-4840 20