Program A Step - LeuchtKraft DMX-4840 Instruction Manual

4.10 Program a step

4. Use Jog wheel #2
indicate
LEUCHTKRAFT
9. Finally press the button CHASE to store the chase then exit the
programming state.
10. Press the button PROGRAM for three seconds to exit Program
mode, the LED goes out indicating this selection.
1. Enter Program mode.
2. Press the button CHASE use jog wheel #1 to select the page
number of the chase to select the program.
3. Press the number button 1-20 to select the Chase number, LEDs
on the BANK button will be all lit, the LCD will show the number and
parameter of the CHASE、BANK、SCENE、STEP、FADE、WAIT.
5. Use jog wheel #1 to select the bank number of the scene, press
number button 1-20 to open.
DMX-4840
to view the steps, the strobe display [002]
programmable step number
19