Running Cue; Over Control - LeuchtKraft DMX-4840 Instruction Manual

NOTE：When you press TAP/INSERT to adjust the speed, adjusting the running speed of
the scene is based on the interval of pressing the Press TAP /INSERT Button twice which
no more than 10 minutes.

6.3 Running CUE

CUE can only run in manual mode.
NOTE: If a CUE includes several chases with different run time, we regard the run time of
the chase with the longest run time as the CUE's longest run time and the chase with short
run time will repeat automatically.

6.4 Over control

Using over control to change the effect specially, you can operate some units solely when
the CUE or CHASE or BANK running. There are two ways to operate:
LEUCHTKRAFT
4. Setting to CHASE RUN BY INSIDE TIME, then it will run as the
FADE TIME or FADE TIME of the step that you set when store the
chase. Setting to CHASE RUN BY OUTSIDE TIME , then it will run
as the FADE TIME or FADE TIME you set last time, you can also
adjust by turn the joy wheel #3 or #4, or use TAP/INSERT Button to
adjust the speed.
1. Press CUE Button, use jog wheel #1 to select chase page.
2. Press number Button 1-20 to select the CUE you anticipant. You
can choose much more than one CUE and they will run on the train
that you select them.
A. When CUE or CHASE or BANK running, press OVERRIDE
button, Then press FIXTURE button, and use number button 1-20
to choose light, so you can push the handspike to change the
effect.
DMX-4840 58