LeuchtKraft DMX-4840 Instruction Manual page 31

LEUCHTKRAFT
4. Press FIXTURE button.
5. Press the number button 1-20 to select the concerned fixtures to
be programmed.
6. Move FADERS1-24 and use Jog wheel #3，#4 to change the
center position of PAN、TILT where you desired. (The codes of the
channel feature of ARRT CODE are "P"、"PF"、"T"、"TF" in the
fixtures bank）for the convenience to check other channels, there
would be some output of the channels, but the channel output will
not be stored in the center.
7. Press MANUAL/REC button, at this moment, all LEDs on CUE、
OVERRIDE、CENTER、FIXTURE GROUP、PRESET、CHASE、
BANK、BLACKOUT flicker at the same time.
8. Press CENTER button.
9. Press the number button 1-20 to select the location to store the
Center, all LEDs flicker for 3 times to indicate that you have
successfully edited a Center position.
DMX-4840 31