Program A Center - LeuchtKraft DMX-4840 Instruction Manual

NOTE: If you press different buttons in step 3 and 7, the fixture group you selected in step 4
will cover the one in step 7.

4.18 Program a Center

LEUCHTKRAFT
8. Press the number button 1-20 to select the fixture group number
you selected in step 2, all LEDs flicker for 3 times
9. Press PROGRAM button for 3 seconds to exit Program mode,
the LED goes out indicating this operation.
1. Enter Program mode.
2. Press FIXTURE button.
3. Press the number button 1-20 to select the concerned fixtures to
be programmed.
4. Move FADERS1-24 and use Jog wheel #3，#4 to change the
center position of PAN、TILT where you desired. (The codes of the
channel feature of ARRT CODE are "P"、"PF"、"T"、"TF" in the
fixtures bank）for the convenience to check other channels, there
would be some output of the channels, but the channel output will
not be stored in the center.
DMX-4840 29