Program A Scene - LeuchtKraft DMX-4840 Instruction Manual

4.4 Program a Scene

LEUCHTKRAFT
9. Press the number button 1-20 to select the Scene number going
to be saved，all LEDs and the Segment Display will flicker for three
times briefly indicating this operation, then the LCD will show the
bank and the scene number of the programmed scene.
10. Repeat steps 2-9 to program other SCENEs with MOVEMENT
11. If you don't intend to continue your programming, press and
hold down the PROGRAM button for three seconds to exit Program
mode, the LED goes out indicating this selection.
1. Enter Program mode.
2. Press the button BANK，to turn on its fader control, which is
indicated by the lit LED, use Jog wheel #1 to select the bank
number to edit the scene.
3. Press the number button 1-20 to open the scene you are going
to edit.
4. Move Faders 1-24 or use the
have saved to change the output of each channel, you can also use
the Jog wheel #1 、 #2 to adjust PAN、 PAN FINE， or use Jog wheel
#3 ， #4to adjust TILT、TILT FINE or press MOVEMENT to add
MOVEMENT function.
5. Press MANUAL/REC to store，LEDs on CUE、OVERRIDE、
CENTER 、 FIXTURE GROUP 、 PRESET 、 CHASE 、 BANK 、
BLACKOUT flicker at the same time.
DMX-4840
CENTER、PRESET、SCENE
12