Program A Scene With Movement - LeuchtKraft DMX-4840 Instruction Manual

4.3 Program a Scene with Movement

LEUCHTKRAFT
1. Enter Program mode.
2. Press the button 1-20 to select Fixture，you can select several
fixtures at a time by tapping of these buttons.
3. Move Faders 1-24 or use the
have saved to change the output of each channel ， press
MOVEMENT button.
4. Press the button 1-10 to select one MOVEMENT in ten，the
selected FIXTURE will run the MOVEMENT.
5. If it is necessary to adjust MOVEMENT parameter， use Jog wheel
#2 to select the adjusting MOVEMENT parameter options(position
& range & fade time or wait time & loop)，use Jog wheel #3、#4 to
adjust parameter values.
6. Repeat Steps 2 – 5to select MOVEMENT for other FIXTURE.
7. Press MANUAL/REC to store into memory，all the LEDs on
CUE、OVERRIDE、CENTER 、FIXTURE GROUP、PRESET、
CHASE、BANK、BLACKOUT flicker to indicate this operation.
8. Press BANK use Jog wheel #1 to select the BANK number to
store the scene.
DMX-4840
CENTER、PRESET、SCENE
11