Setting A Scene - LeuchtKraft DMX-4840 Instruction Manual

4.2 Setting a scene

LEUCHTKRAFT
1. Enter Program mode.
2. Press the button 1-20 to select Fixture，you can select several
fixtures at a time by tapping of these buttons.
3. Slide Faders 1-24 or use the
SCENE
have saved to change the output of each channel。You
can also use the jog wheel #1 、#2 to control the PAN、 PAN FINE
or use the jog wheel #3 ，#4 to control TILT、TILT FINE.
4. Once the scene is satisfactory, press MANUAL/REC button to
program this scene into memory. At this moment, the LEDs on
CUE、OVERRIDE、CENTER 、FIXTURE GROUP、PRESET、
CHASE、BANK、BLACKOUT button flicker at the same time.
5. Press BANK use the Jog wheel #1 to select the BANK number to
save the scene.
6. Press the number button 1-20 to select the Scene number going
to be saved，all LEDs and the Segment Display will flicker three
times briefly indicating this operation, then the LCD will show the
bank and the scene number of the programmed scene.
7. Repeat steps 2-6 to program other scenes.
8. Press PROGRAM button for 3 seconds to exit Program mode,
the LED goes out indicating this selection。
DMX-4840
CENTER or PRESET or
10