Rear View; Operation Guide; Programming Mode - LeuchtKraft DMX-4840 Instruction Manual

3.2 Rear View

1. Power in
2. Power Switch
3. STROBE
4. AUDIO
5. MIDI IN or MIDI THRU
6. DMX Out
7. STAND ALONE

4. Operation Guide

DMX-4840 Operating Steps Instructions
When power is turned on, the controller starts self testing automatically, the LCD Display
indicating the self testing progress. After it is finished, the fixture pilot on the rear board is
on, which means that you can start to operate the controller.

4.1 Programming Mode

LEUCHTKRAFT
Press PROGRAM button for 3 seconds, the LED above this button
lights flickers indicating Program in active.
DMX-4840
AC100-240V 50/60Hz.
This switch turns On/Off the power.
Trigger non-DMX strobe. Signal +12V DC.
0.1V~1Vp-p.
Receives MIDI data.
Two connectors sends DMX signals to DMX
fixtures, use 3 pin XLR plug cable to link the
fixture together.
The connectors are used only in master/slave
mode, using 5 pin XLR cable microphone jack of
the first fixture, you will find that the remote
control on the first unit will control all the other
units for Stand by, Function and Mode.
9