Fuel Filter - Honda 1986 GoldWing GL1200A Manual

Fuel Filter - - - - - - - - - - - - - - - - - - - - - - -
WARNING:
• Gasoline Is flammable and Is explosive under cer-
tain conditions. Do not smoke or allow flames or
sparks in your working area.
• The fuel lines are pressurized. Wear eye protection
when working on the fuel system. If gasoline gets
In your eyes, flush with water and get prompt
medical attention.
Turn the fuel valve and ignition switch OFF.
Wrap a shop towel around the fuel line and fittings.
Loosen the fuel line banjo bolts slowly to drain the lines
and filter and to keep gasoline from spraying out.
Remove the banjo bolts to disconnecl the fuel lines.
Loosen the 6 mm clamp bolt. and remove the filter from
its bracket.
Install the new filter in the filter bracket. Connect the fuel
lines
NOTE: Use new sealing washers Align the fuel line with
the filter stopper.
Tighten the banjo bolts
Torque: 22 N.m (16 ft-Ib)
Tightel"' the 6 mm clamp bolt.
Open and close the throttle 2 or 3 times and make sure
that the fuel line doesn't interfere with the throttle linkage.
Turn the ignition switch ON to check tor fuel line leaks.
SEALING
WASHERS
BANJO BOLT
FUEL FILTER
3-3