Throttle (0Th) Sensor - Honda 1986 GoldWing GL1200A Manual

CFI System
Throttle (8th) Sensor
(cont'd)
Removal/Installation
Remove the air chamber cover. Remove the cotter pin
and washer, Disconnect the throttle link from the throttle
arm.
Unscrew th'3 three bolts and remove the fuel delivery
pipes. Unbolt and remove the throWe body and wire
screen.
Center punch the break head bolt. Break the head off the
bolt by drilling a 9 mm (0.35 In) hole through the marked
location
Install a new sensor on the throttle body using new break
head bolts.
NOTE: Do not break the heads off the bolts until after ad-
justing the sensor,
Install the throttle body on the engine. Insert the 2.9 mm
gauge between the throttle valve ann and stop screw.
Turn the sensor until the output voltage is 0.475-0.495.
Start the engine and recheck the voltage. If the voltage is
OK, tum Ihe bolts further to break off the heads.
10-26