Honda 1986 GoldWing GL1200A Manual page 159

RETURN SPRING
Cruise Control
Junction Box
(cont'd)
Assembly/Installation
CAUTION: Keep contaminants away from Junction box
sliding surfaces. Clean parts with solvent before
assembly.
Coat the sliding faces of the control arm and shaft with
grease.
Hook the ends of the return spring against the case and
arm securely with the control arm in the six o'clock posi-
tion. Rotate the control arm counterclockwise to the
twelve o'clock position and push it back into the junction
box assembly.
Connect the throttle cables to the junction box. Coat the
sliding faces of the cable drum and drum shaft with
grease.
Insert the ends of the throttle cables into the slots in the
cable drum. Install the cable drum In the case.
NOTE Install the cable drum wIth the stopper facing the
inside Connect the cables to the cable drum with the
stopper contacting the control arm.
Install the washer and a new circlip on the drum shaft. In-
stall the circlip with the sharp edge facing out. Be sure
the circlip
IS
seated all the way around the circlip groove.
SPRING ENDS
CONTROL ARM
"""'-:::::::::"""'---
~TOPPER
~~~H
••
CABLE DRUM CIRCLIP
Grease the end of the actuator cable and connect the
cable end to the control arm.
Tighten the cable JOint lock nut.
Recheck the throttle grip operation.
Install the junction box on the bracket.
Adjust the throttle cables (see page' 3-22).
13-20