Honda 1986 GoldWing GL1200A Manual page 99

Installation
Working from the left side, push the air chamber partially
into place and connect the throttle cables to the throttle
drum. Check the cables for smooth operation.
NOTE: Make sure the throttle cable is connected in the
junction box.
If a new throttle grip cancel switch or throttle cable holder
IS
installed. adjust the switch Isee page 28-11).
Push the air chamber into place.
NOTE: Check that the hose and pipes are not caught on
surrounding parts and disconnected.
Apply a thin coat of clean engine oil to the pressure
regulator a-rings, and install the right fuel delivery pipe.
Connect the vacuum hoses to the pressure regulator.
Connect the air outlet and inlet hoses to the air chamber
On California models. connect the purge aJr hose to the
purge control valve.
Connect the secondary air supply hoses to the cylinder
heads and to the holders on the engine case.
Connect the fuel lines to the right and left fuel delivery
pipes and temporarily tighten the banjo nuts.
NOTE: Tighten the nuts after the Intake pipes have been
installed.
(cont'd)
10-39