Honda 1986 GoldWing GL1200A Manual page 136

Auto Leveling Rear Suspension
~ir ~istributor (cont'd)~~~~~~~~~~~~~~~~~~~~~~
Installation
PoSItion the air distributor in the right fairing pocket with
the relief hose facing forward.
Install the spring, spring seat, and steel ball into the air
distributor hose joint Apply clean engine oil or grease to
the O·ring.
Position the air hose facing left and tighten the hose joint
bolt.
Torque: 55 N.m (41 ft·lb)
Route the relief hose through the forward fairing hole.
Position the hose ioints onto the fairing grommets. Use a
chemlcellubricant (CRC 5-56 or equivalent) to help posi·
tion the hose jOints
Route the air relief hose.
NOTE: Be careful not to pinch the air relief hose. If the
hose is blocked or restricted, the RHC reacts as if the
pressure sensor
IS
faulty and shuts the system down.
Connect the front and rear air hoses to the air distributor
joints.
NOTE: Do not Interchange front and rear alf hose posi·
tions. Use a wrench to keep the hose joints from turning
while tightening the hose coupler.
Tighten the hose jomt nuts.
Torque: 12.5 N.m (9 ft-Ib)
12·22