Fuel Pump - Honda 1986 GoldWing GL1200A Manual

TEMPERATURE
SENSOR
Sensor Inspection
Inspect the sensor following the same steps used to test
the T1 sensor (see page 10-18).
Removaillnstallation
DIGITAL CIRCUIT
fESTER
Remove the throttle body/air chamber assembly (see
page 10-34) Remove the sensor from the thennostat
housIng, and plug the hole with a cap.
Install the sensor in the reverse order of removal.
NOTES.
• Coat the sensor threads with a sealing agent before in-
stallation .
• After Installation. check for leaks and check the
coolant level.
THERMOSTAT HOUSING
c
\.
Main/Fuel Pump Relay Inspection
Fuel pump capacity: 630 cc (21.3 oz)lmlnute minimum
Measure the amount of fuel discharged.
Engage the transmission With the clutch lever out, and
push the starter button so the starter motor will not work
Out the fuel pump operates.
Fuel Pump - - - - - - - - - - - - - - - - - - - - - - - -
Operation Inspection ;"--_
Turn the ignition OFF. Disconnect Ihe fuel line from the •
left fuel delivery pipe by removing the joint nut.
Remove the relay from the fuse/relay box.
Check tor no continuity between tenninals 11 ) and (2). If
there is continuity. install a new relay.
Apply battery voltage across tenninals (3) and (4) and
check tor continuity between terminals
(1) and (2).
If
there is no continuity, Install a new relay,
lcont'd)
RELAY
\
~
U=====L::Pl
2
~~
10-31