Honda 1986 GoldWing GL1200A Manual page 133

..
-
AIR HOSE
SPRING SEAT
/
/
STEEL BALL
If pressure does not remain steady, remove the solenoid
valve and replace the rubber seat at the top of the rod.
Remove the pressure sensor from the air distributor. At-
tach a hand air pump to the front outlet joint and apply
pressure.
Reinstall the spring, spring seat, and steel ball in the hose
Joint. Connect the air hose to the air distributor.
Inspection (Solenoid Valve)
While maintaining pressure, apply battery voltage bet·
ween the Br/R
(+)
and G (-) terminals of the solenoid
valve coupler.
If pressure is not relieved through the mounting hole of
the pressure sensor, install new solenoid valve(s).
If pressure remains steady even when the solenoid valve
is activated, clean the air passage in the air distributor.
Repeat the above procedure for the rear Side applying
battery voltage between the BrtY (
+ )
and G (- ) terminals
of the valve coupler
PRESSURE PUMP
Apply vacuum to the air distributor relief port. If vacuum
does not remain steady, remove the solenoid valve and
replace the rubber seat at the top of the rod.
While maintaining vacuum, apply battery voltage between
the Br/W (+) and G ( -) terminals of the solenoid coupler.
Vacuum should be relieved slowly.
If vacuum is relieved quickly, install a new air control nee-
dle in the relief port.
If the valves do not "click". instaJl new ones.
RELIEF HOSE
If vacuum remains steady even when the the solenoid
valve is activated, clean the air distributor relief port.
(conrd)
12·19