Honda 1986 GoldWing GL1200A Manual page 30

Engine Removal/Installation
Removal
(cont'd) - - - - - - - - - - - - - - - - - - - - - - - - - - -
Move the engine forward to disengage the output shaft
from the universal joint.
Malle the engine out of the frame.
CAUTION: Be careful not to damage the brake lines
during engine ,emoval.
Installation - - - - - - - - - - - - - - - - - - - - - - -
Install the engine in the reverse order of removal.
Lubricate the output shaft splines with a multipurpose
NLGI no. 2 grease with 40% molybdenum disulfide
(MoS2) additive.
Carefully manuel/er the engine into the frame while align-
ing the output shaft with the universal joint.
CAUTION: Be careful not to damage the brake lines
during Installation.
Sl1de the output shaft back into the universal joint.
CAUTION: Car fully align mounting points with the
Jack to prevent damage to mounting bolt threads, wire
harnesses and cables.
Hand tighten mounting bolts and nuts land Install parts
noted) In this order:
1. The left and then the right rear mount bolts.
2. The subframe and footpeg bolts.
3. The forward mount bolt.
4. The right and left mount brackets and upper engine
mount bolts, Including the battery ground with the left
side mount.
5. The upper and lower front mount bracket bolts.