Endurance Wiring Loom - Porsche 911 GT3 Cup MR Gen. II Technical Manual

6.2 Endurance Wiring Loom

► In the 911 GT3 Cup MR Gen.II, a fully integrated endurance wiring loom is used to connect all the
necessary systems. The 911 GT3 Cup MR Gen.II is equipped with the cockpit wiring harness and
the front wiring harness as standard. The rear wiring harness with connection options for air conditi-
Before each event, all wiring harnesses must be checked for chafing
NOTE
and the connectors for correct fitting.
If the optionally available rear wiring loom is not used, a corresponding
NOTE
dummy controller must be connected to the separation point (rear IO)
The front IO control unit is located in the cars' front section. Weather
NOTE
conditions can cause moisture to get into the connector. After driving
in wet conditions, the connector should be disconnected from the
control unit and a check completed for moisture ingress.
Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
ELECTRICS | Endurance Wiring Loom
5 Nm
10 Nm
Home
63