Vacon 100 Industrial Applications Manual page 89

MONITORING MENU
3 You can monitor only 2 values as trend curves at
the same time. The current selections,
FreqReference and Motor speed, are at the bottom
of the display. To make a selection of the current
value that you wish to change, use the arrow
buttons up and down. Push OK.
4 Go through the list of the monitoring values with
the arrow buttons.
5 Make a selection and push OK.
STOPPING THE PROGRESSION OF THE CURVE
The Trend curve function also lets you to stop the curve and read the current values. After,
you can start the progression of the curve again.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
READY
STOP
FreqReference
Motor Speed
READY
STOP
FreqReference
ID:3 V2.2.1.1.4
Output frequency
FreqReference
Motor Speed
Motor Current
Motor Torque
Motor Shaft Power
READY
STOP
Motor Current
Motor Speed
VACON · 89
I/O
0.00Hz
0rpm
I/O
I/O
0.00A
0rpm
4