Vacon 100 Industrial Applications Manual page 261

PARAMETER DESCRIPTIONS
Table 126: The output signals through RO1
Selection
Selection name
number
0 Not used
1 Ready
2 Run
3 General fault
4 General fault inverted
5 General alarm
6 Reversed
At speed
7
8 Thermistor fault
Motor regulator activated
9
10 Start signal active
Keypad control active
11
I/O control B active
12
13 Limit supervision 1
14 Limit supervision 2
15 Fire mode active
16 Jogging active
Preset Frequency active
17
18 Quick Stop active
19 PID in Sleep mode
20 PID Soft Fill activated
PID feedback supervision
21
ExtPID feedback supervision
22
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Description
The output is not used.
The AC drive is ready to operate.
The AC drive operates (the motor runs).
A fault trip occurred.
A fault trip did not occur.
An alarm occurred.
The reverse command is given.
The output frequency has become the same as the set fre-
quency reference.
A thermistor fault occurred.
One of the limit regulators (for example current limit or tor-
que limit) is activated.
The start command of the drive is active.
The selection is keypad control (the active control place is
keypad).
The selection is I/O control place B (the active control place
is I/O B).
The limit supervision activates if the signal value goes below
or above the set supervision limit (P3.8.3 or P3.8.7).
The Fire mode function is active.
The Jogging function is active.
The selection of preset frequency was made with digital input
signals.
The Quick stop function is activated.
The PID controller is in the sleep mode.
The Soft fill function of the PID controller is activated.
The feedback value of the PID controller is not in the supervi-
sion limits.
The External PID controller feedback value is not in the
supervision limits.
VACON · 261
10