PARAMETER DESCRIPTIONS
Fig. 78: The location of the pressure sensor
A. Mains
B. Inlet
Input Pressure
Supervision
Alarm Level
Supervision
Fault Level
PID Setpoint
PID Setpoint
Input Pressure Alarm
(Digital output signal)
Motor Running
Fig. 79: The Input pressure supervision function
P3.13.9.1 ENABLE SUPERVISION (ID 1685)
Use this parameter to enable the Input Pressure Supervision function.
Use this function to make sure that there is enough fluid in the inlet of the pump.
P3.13.9.2 SUPERVISION SIGNAL (ID 1686)
Use this parameter to select the source of the input pressure signal.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
A
PT
B
C
C. Outlet
Input Pressure Monitor
Supervision
Fault Delay
Supervision
Fault Delay
PID Setpoint
Reduction
VACON · 305
Yes
No
10