Vacon 100 Industrial Applications Manual page 244

VACON · 244
5 If the digital input DI6 was already used for some
other function, a message scrolls on the display.
Change one of these selections.
After the steps, a digital signal to the digital input DI6 controls the function External Fault
Close.
The value of a function can be DigIN Slot0.1 (in the graphical display) or dI 0.1 (in the text
display). In these conditions, you did not give a terminal to the function, or the the input was
set to be always OPEN. This is the default value of most of parameters in the group M3.5.1.
On the other hand, some inputs have the default value always CLOSED. Their value shows
DigIN Slot0.2 in the graphical display and dI 0.2 in the text display.
NOTE!
You can also give time channels to digital inputs. There is more data about it in
Table 89 Sleep function settings.
10.6.1.2 Programming of analogue inputs
You can make a selection of the target input for the signal of the analogue frequency
reference from the available analogue inputs.
Fig. 45: The Analogue inputs menu in the graphical display
A. The graphical display
B. The name of the parameter
10
A
READY
STOP
Analog Input 1
ID:377
AI1 Signal Sel
AnINSlotA.1
AI1 Filter Time
AIl Signal Range
0-10V/0-20mA
C. The value of the parameter, that is, the
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
PARAMETER DESCRIPTIONS
B
I/O
P3.5.2.1.1
0.10s
C
set analogue input