Vacon 100 Industrial Applications Manual page 263

PARAMETER DESCRIPTIONS
Table 126: The output signals through RO1
Selection
Selection name
number
Block Out.1
44
Block Out.2
45
Block Out.3
46
Block Out.4
47
Block Out.5
48
Block Out.6
49
Block Out.7
50
Block Out.8
51
Block Out.9
52
Block Out.10
53
54 Jockey pump control
55 Priming pump control
56 Auto-cleaning active
Motor Switch Open
57
58 TEST (Always Closed)
59 Motor preheat active
60 AHF Capacitor Disconnect
AHF Capacitor Disconnect
61
Inverted
62 Run Indication
P3.5.3.2.2 RO1 ON DELAY (ID 11002)
Use this parameter to set the ON delay for the relay output.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Description
The output of the programmable Block 1. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 2. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 3. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 4. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 5. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 6. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 7. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 8. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 9. See parameter
menu M3.19 Drive customizer.
The output of the programmable Block 10. See parameter
menu M3.19 Drive customizer.
The control signal for the external jockey pump.
The control signal for the external priming pump.
The Pump auto-cleaning function is activated.
The Motor Switch function has detected that the switch
between the drive and the motor is open.
VACON · 263
10