Vacon 100 Industrial Applications Manual page 253

PARAMETER DESCRIPTIONS
NOTE!
This parameter has no effect if the external PID controller is not enabled in Group
3.14.
P3.5.1.33 EXTERNAL PID SETPOINT SELECTION (ID 1048)
Use this parameter to set the digital input signal that selects the PID setpoint value to be
used.
P3.5.1.34 MOTOR 1 INTERLOCK (ID 426)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.35 MOTOR 2 INTERLOCK (ID 427)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.36 MOTOR 3 INTERLOCK (ID 428)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.37 MOTOR 4 INTERLOCK (ID 429)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.38 MOTOR 5 INTERLOCK (ID 430)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.39 MOTOR 6 INTERLOCK (ID 486)
Use this parameter to select the digital input signal that is used as interlock signal for the
Multi-Pump system.
P3.5.1.40 RESET MAINTENANCE COUNTER (ID 490)
Use this parameter to select the digital input that reset the value of the Maintenance
Counter.
P3.5.1.41 ENABLE DI JOGGING (ID 532)
Use this parameter to enable the jogging commands from digital inputs.
This parameter has no effect on the jogging from fieldbus.
P3.5.1.42 JOGGING REFERENCE 1 ACTIVATION (ID 530)
Use this parameter to set the digital input signals that activate the Jogging function.
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
VACON · 253
10