Vacon 100 Industrial Applications Manual page 254

VACON · 254
NOTE!
If the input is activated, the drive starts.
P3.5.1.43 JOGGING REFERENCE 2 ACTIVATION (ID 531)
Use this parameter to set the digital input signals that activate the Jogging function.
NOTE!
If the input is activated, the drive starts.
P3.5.1.44 MECHANICAL BRAKE FEEDBACK (ID 1210)
Use this parameter to set the brake status feedback signal from mechanical brake.
Connect this input signal to the auxiliary contact of the mechanical brake. If the contact is not
closed within the given time, the drive shows a fault.
P3.5.1.45 FIRE MODE ACTIVATION OPEN (ID 1596)
Use this parameter to select the digital input signal that activates the Fire Mode function.
This parameter activates the Fire Mode if it is enabled with a correct password.
P3.5.1.46 FIRE MODE ACTIVATION CLOSE (ID 1619)
Use this parameter to select the digital input signal that activates the Fire Mode function.
This parameter activates the Fire Mode if it is enabled with a correct password.
P3.5.1.47 FIRE MODE REVERSE (ID 1618)
Use this parameter to select the digital input signal that gives a command for reverse
rotation direction during the Fire Mode.
This function has no effect in normal operation.
P3.5.1.48 AUTO-CLEANING ACTIVATION (ID 1715)
Use this parameter to select the digital input signal that starts the Auto-cleaning.
The Auto-cleaning stops if the activation signal is removed before the process is complete.
NOTE!
If the input is activated, the drive starts.
P3.5.1.49 PARAMETER SET 1/2 SELECTION (ID 496)
Use this parameter to set the digital input that selects the parameter set to be used.
This function is enabled if any other slot than 'DigIN Slot0' is selected to this parameter. The
parameter set selection is allowed only when the drive is stopped.
Contact Open = Parameter Set 1 is loaded as the active set
Contact Closed = Parameter Set 2 is loaded as the active set
10
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
PARAMETER DESCRIPTIONS