Vacon 100 Industrial Applications Manual page 349

FAULT TRACING
Fault
Fault ID Fault name
code
100 1100 Soft fill timeout
101 1101 Feedback supervision
fault (PID1)
105 1105 Feedback supervision
fault (ExtPID)
109 1109 Input pressure super-
vision
1409
111 1315 Temperature fault 1
1316
112 1317 Temperature fault 2
1318
118 1118 AHF Over Temp
LOCAL CONTACTS: HTTP://DRIVES.DANFOSS.COM/DANFOSS-DRIVES/LOCAL-CONTACTS/
Possible cause
There is a timeout in the
Soft fill function in the PID
controller. The process
value was not achieved in
the time limit.
A pipe that broke can be the
cause.
The PID controller: the feed-
back value is not in the
supervision limits (P3.13.6.2
and P3.13.6.3) and the delay
(P3.13.6.4), if you set the
delay.
The external PID controller:
the feedback value is not in
the supervision limits
(P3.14.4.2 and P3.14.4.3)
and the delay (P3.14.4.4), if
you set the delay.
The supervision signal of the
input pressure (P3.13.9.2) is
lower than the alarm limit
(P3.13.9.7).
The supervision signal of the
input pressure (P3.13.9.2) is
lower than the fault limit
(P3.13.9.8) .
1 or more of the tempera-
ture input signals (set in
P3.9.6.1) is higher than the
alarm limit (P3.9.6.2).
1 or more of the tempera-
ture input signals (set in
P3.9.6.1) is higher than the
fault limit (P3.9.6.3).
1 or more of the tempera-
ture input signals (set in
P3.9.6.5) is higher than the
fault limit (P3.9.6.6).
1 or more of the tempera-
ture input signals (set in
P3.9.6.5) is higher than the
fault limit (P3.9.6.7).
The advanced harmonic fil-
ter function has caused an
overtemperature fault
through a digital input.
VACON · 349
How to correct the fault
Do a check of the process.
Do a check of the parameters in
the menu M3.13.8.
Do a check of the process.
Do a check of the parameter set-
tings, the supervision limits and
the delay.
Do a check of the process.
Do a check of the parameters in
menu M3.13.9.
Do a check of the input pressure
sensor and connections.
Find the cause of the temperature
rise.
Do a check of the temperature
sensor and connections.
If no sensor is connected, make
sure that the temperature input is
hardwired.
See the option board manual for
more data.
Do a check of the advanced har-
monic filter function.
11