Parameter Addressing With 16-Bit Pnu Plus 16 Bit Subindex (Profidrive) - KEB COMBIVERT F5 Instructions For Use Manual

PROFINET AcycLIc DATA (PARAMETER cHANNEL) AccORDING TO PROFIDRIVE
If an error has occurred during the read access to a parameter, the response ID = 81h
is set. Furthermore, the format = 44h (error) is set for this parameter value and the error
value is set as 16-bit value as follows:
Value
(*4)
(*5)
(to *3)

4.2.1 Parameter addressing with 16-bit PNU plus 16 bit Subindex (PROFIdrive)

1. PNU
0000h
(*1)
11h Timeout on access to the parameter or drive converter busy
14h
00h
17h
65h Error in internal communication (BCC error)
66h Error in internal communication (invalid service or invalid operation)
67h
68h Error in internal communication (invalid telegram)
69h Error in internal communication (parity error)
03h
6Bh Error in internal communication (invalid operation) (*5)
The error code „drive converter busy" was changed in the software version
V3.1 from 11h to 14h.
The error code „invalid operation" was changed in the software version
V3.1 from 66h to 6Bh.
Free from error requests are listed in a negative Write-response (Re-
sponse-ID = 82h) with format = 40h (Zeror) and No of Values = 0.
Last PNU
FFFFh Parameters of the drive converter control and operator with
PNU = KEB-Parameter-Address (*1). KEB uses the subin-
dex for set-addressing. Parameters of the operator always
start at PNU = XX80h
The KEB parameter address can be found here or in [5]. It is also possible to
display the KEB parameter address in the KEB start-up software COMBIVIS
(more information see annex).
Description
Drive converter busy (*4)
Invalid parameter address or password
Data invalid
Invalid password
Invalid parameter set (subindex)
Description
19