KEB COMBIVERT F5 Instructions For Use Manual page 49

PARAMETER DEScRIPTION
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
Fb11
cfgNrPDOUTS
This parameter has two meanings. In mormal mode, the value of this param-
eter indicates how many PDOUT units are activated internally. Each inter-
nal PDOUT unit transfer 8 bytes PDOUT data in normal mode. Additionally
the parameter determines which PDOUT submodule is configured in slot2.
The adjustment of this parameter must agree with the project design in the
PROFINET controller.
028Bh
0
Uint8
1 (corresponds to 8 byte PDOUT data)
2 (corresponds to 16 byte PDOUT data)
1 (corresponds to 8 byte PDOUT data)
A changed value is stored non-volatile, but active only at the next switch on.
This parameter is write protected, if Fb01 FBS Config.Bit5 is 1.
Fb12
ActiveNrPDINS
Indicates the number of active PDIN units in normal mode.The value of this
parameter usually corresponds to the value of FB10. The cause that the two
parameter values differ is that the connected drive converter control supports
only one PDIN unit.
028Ch
0
Uint8
1 (corresponds to 8 byte PDIN data)
2 (corresponds to 16 byte PDIN data)
1 (corresponds to 8 byte PDIN data)
The value of this parameter can only be read.
49