KEB COMBIVERT F5 Instructions For Use Manual page 22

DIFFERENcES bETWEEN NORMAL AND SyNcHRONOUS MODE
Maximum PD transfer rate at 8 Byte PD data
(*1)
Maximum PD transfer rate at 16 Byte PD data
(*1)
Acyclic ProfiNet communication
Diagnosis via the diagnostic interface (X6B)
Diagnosis via TCP/UDP via the PROFINET
interface
Support by FI controls
Flexibility of the process data assignment
Parameter group in the FI for setting the PD
assignment
(*1) Here it concers to the internal process data transfer rate between the opera-
(*2) Theoretically possible, non-guaranteed transfer rate, depends at acyclic organ-
(*3) Guaranteed, strictly cyclical.
22
Feature
tor and drive converter control. There are higher transfer rates possible to the
PROFINET.
ized communication strongly on the general communication load between oper-
ator and drive converter.
Normal mode Synchronous
mode
1000 µs (*2) 2000 µs (*3)
2000 µs (*2) 2000 µs (*3)
fully supported fully supported
fully supported fully supported
fully supported fully supported
all Not all
restricted almost in any
order
Sy Pd