KEB COMBIVERT F5 Instructions For Use Manual page 48

PARAMETER DEScRIPTION
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
48
Fb09
PDIN2_Hsp5Service
The adjustment of this parameter is only relevant for the normal mode.
Indicates the service code for the KEB internal protocol HSP5 to read the
second 8 PDIN data byte from the operator to the drive converter control, if
activated. The value must be suitable adjusted to the PDIN mapping in the
drive converter.
0289h
0
Uint8
19: PDIN assignment only with 32 bit values
20: PDIN assignment only with 16 bit values
51: PDIN assignment only with 32 bit values, full duplex (*1)
52: PDIN assignment only with 16 bit values, full duplex (*1)
53: PDIN assignment with 1 32-bit- and 1-2 16-bit values, full duplex (*1)
20
A changed value is stored immediately active and non-volatile.This parame-
ter is write protected, if Fb01 FBS Config.Bit5 is 1.
Fb10
cfgNrPDINS
This parameter has two meanings. In mormal mode, the value of this pa-
rameter indicates how many PDIN units are activated internally. Each
internal PDIN unit transfer 8 bytes PDIN data in normal mode. Additionally
the parameter determines which PDIN submodule is configured in slot1.
The adjustment of this parameter must agree with the project design in the
PROFINET controller.
028Ah
0
Uint8
1 (corresponds to 8 byte PDIN data)
2 (corresponds to 16 byte PDIN data)
1
A changed value is stored non-volatile, but active only at the next switch on.
This parameter is write protected, if Fb01 FBS Config.Bit5 is 1.