KEB COMBIVERT F5 Instructions For Use Manual page 46

PARAMETER DEScRIPTION
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
(*1): In case of full duplex services the PDOUT data are transferred in Request to the drive converter
control and Response contains the PDIN data. PDOUT data and PDIN data are independently trans-
ferred at non-full duplex services. The outcome of this at full duplex services is that the values for
PDOUT_Hsp5Service/ PDOUT2_Hsp5Service and PDIN_Hsp5Service/ PDIN2_Hsp5Service must
be identical.
46
Fb05
PDOUT1_Hsp5Service
The adjustment of this parameter is only relevant for the normal mode. Indi-
cates the service code for the KEB internal protocol HSP5 to output the first
8 PDOUT data byte from the operator to the drive converter control. The val-
ue must be suitable adjusted to the PDOUT mapping in the drive converter.
0285h
0
Uint8
16: PDOUT assignment only with 32 bit values
17: PDOUT assignment only with 16 bit values
48: PDOUT assignment only with 32 bit values, full duplex (*1)
49: PDOUT assignment only with 16 bit values, full duplex (*1)
50: PDOUT assignment with 1 32-bit- and 1-2 16-bit values, full duplex (*1)
17
A changed value is stored immediately active and non-volatile.This parame-
ter is write protected, if Fb01 FBS Config.Bit5 is 1.
Fb06
PDIN1_Hsp5Service
The adjustment of this parameter is only relevant for the normal mode. Indi-
cates the service code for the KEB internal protocol HSP5 to read the first 8
PDIN data byte from the operator to the drive converter control.
The value must be suitable adjusted to the PDIN mapping in the drive con-
verter.
0286h
0
Uint8
16: PDIN assignment only with 32 bit values
17: PDIN assignment only with 16 bit values
48: PDIN assignment only with 32 bit values, full duplex (*1)
49: PDIN assignment only with 16 bit values, full duplex (*1)
50: PDIN assignment with 1 32-bit- and 1-2 16-bit values, full duplex (*1)
17
A changed value is stored immediately active and non-volatile.This parame-
ter is write protected, if Fb01 FBS Config.Bit5 is 1.