KEB COMBIVERT F5 Instructions For Use Manual page 47

PARAMETER DEScRIPTION
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
ID:
Name:
Meaning
Parameter number (PNU):
Subindex:
Data type:
Coding:
Standard value:
Note:
Fb07
PDIN_cycle
The adjustment of this parameter is only relevant for the normal mode. The
contents of the PDIN data are read cyclically in normal communication mode.
The value of this parameter preset the cycle time in ms.
0287h
0
Uint16
1ms
25ms
A changed value is stored immediately active and non-volatile.
Fb08
PDOUT2_Hsp5Service
The adjustment of this parameter is only relevant for the normal mode.
Indicates the service code for the KEB internal protocol HSP5 to output the
second 8 PDOUT data byte from the operator to the drive converter control,
if activated.
The value must be suitable adjusted to the PDOUT mapping in the drive
converter.
0288h
0
Uint8
19: PDOUT assignment only with 32 bit values
20: PDOUT assignment only with 16 bit values
51: PDOUT assignment only with 32 bit values, full duplex (*1)
52: PDOUT assignment only with 16 bit values, full duplex (*1)
53: PDOUT assignment with 1 32-bit- and 1-2 16-bit values, full duplex (*1)
20
A changed value is stored immediately active and non-volatile.This parame-
ter is write protected, if Fb01 FBS Config.Bit5 is 1.
47