Setting Start Direction Of Count Measurement Surfaces - Omron ZW-C1*AT User Manual

Setting Start Direction of Count Measurement Surfaces

Setting Start Direction of Count Measurement Surfaces p.78
As an example, here is an explanation of the procedure for setting start direction of count measurement surface
to "NEAR".
Operating procedure
Steps Key operation
1
2
3
4
ZW User's Manual
Display Description
Press and hold the
mode.
Press the
Select the material.
NEAR: NEAR direction
FAR: FAR direction
The current setting value is displayed on the sub-display.
Press
In this example, select "NEAR" and press the
Press the
key for two seconds to enter the FUN
/ keys to select "SUR.DUR" and press the
key.
/ key to enter editing mode and the sub-display blinks.
key for two seconds to enter the RUN mode.
key.
303
Setting Sensing