Omron ZW-C1*AT User Manual page 145

1
Set the operating mode to the FUN mode.
3-3 Switching operation modes p.61
 Explorer pane
 Edit pane
 I/O Setting Screen
2
Select ON/OFF from [Monitor Focus].
3
Enter the [Distance] and [Output value] at
[Point1].
4
Likewise, enter the [Distance] and [Output
value] at [Point2].
Adjusting the analog output value
Discrepancies may occur between the current value/voltage value output as analog set on the Sensor
Controller and the current value/voltage value actually measured due to the conditions for the connected
external device or other factors.
The analog output adjustment function can be used to correct this discrepancy.
The output values are corrected by entering the adjustment value for the current or voltage values for any two
points.
Important
Set the output destination and select either current or voltage output beforehand. Also, connect the analog output
signal line to an external ammeter or voltmeter.
Item Setting item Setting value
Analog out- Analog output adjustment
put adjust-
Point1 Reference value
ment
(current/value)
adjustment value -999 to 999
Point2 Reference value
(current/value)
adjustment value -999 to 999
1
Set the operating mode to the FUN mode.
3-3 Switching operation modes p.61
ZW User's Manual
: [Bank] | [(Bank Data Name)] (double click)
: [I/O Settings] icon (
: [Analog output]
Description
ON/OFF (default value)
4 to 20 [mA]/-10 to 10 [V]
4 to 20 [mA]/-10 to 10 [V]
)
Set analog output correction ON/OFF.
Sets the current or voltage to be used as the correction
reference in the entry field on the left.
Sets the adjustment value when the reference value is
measured in the entry field on the right.
Sets the current or voltage to be used as the correction
reference in the entry field on the left.
Sets the adjustment value when the reference value is
measured in the entry field on the right.
Parallel I/O connection
143