Connecting Fiber Cable - Omron ZW-C1*AT User Manual

Connecting Fiber Cable

Connect the fiber cable on the Sensor Head to the Sensor Head connector on the Sensor Controller as follows:
1
Remove the protective caps from the Sensor Controller's fiber connector and the fiber cable.
Protective cap
Important
Do not discard but keep the protective cap handy.
2
Mate the convex section on the fiber cable with the groove on the fiber connector and turn the
threaded section clockwise while pushing in (see figure 1).
(Figure 1)
Fiber cable
In the "No good" status in figure 2 and figure 3, optic signals cannot be transmitted and correct
measurement is not possible. Always check that the system is in the "Good" status.
38
Installation
Fiber connector
Groove
Convex
section
Threaded
section
Fiber
connector
Protective cap
Fiber cable
(Figure 2)
(Figure 3)
Good No good
Good No good
ZW User's Manual