Setting Start Direction of Count Measurement Surfaces
When a number of measurement surfaces exists, start direction can be selected from NEAR side or FAR side.
Example: NEAR
Item
Setting item
Operation mode Start direction of
count
measurement
surfaces
Important
More 5 surfaces from NEAR side are not counted as a surface.
Note
The setting of start direction of count measurement surfaces can also be set by the operating keys on the Sensor
Controller.
Setting Start Direction of Count Measurement Surfaces p.208
120
Setting Sensing
1 surface
2 surface
3 surface
4 surface
Setting value
NEAR (default value)
FAR
Example: FAR
4 surface
3 surface
Description
Measurement surfaces are counted from NEAR side.
Measurement surfaces are counted from FAR side.
2 surface
1 surface
ZW-7000/5000
User's Manual