Automatic Redial - Ricoh Aficio 340 System Settings

SENDING A FAX MESSAGE
the other end is shown on the dis-
play.
Reference
2
P.193 "RTI/TTI"
After transmission, the machine
will return to standby mode.
- - Checking the Transmission
- -
Result
• Turn the Transmission Result Re-
port on if you want a report to be
printed after every successful
transmission.
TRANSMISSION"
If you leave the Transmission Re-
sult Report off, the report will not
be printed after every transmis-
sion. However, should a transmis-
sion fail, a Communication Failure
Report will be printed instead.
• If you turn the Transmission Re-
sult Report (Memory Transmis-
sion) off, the Error Report will be
printed when the communication
on fails.
• You can also check the transmis-
sion result by examining the TCR.
P.116 "PRINTING THE TCR"
You can either print or scroll
through the TCR on the display.
P.110 "CHECKING THE TRANS-
MISSION RESULT (TX STATUS)"
26
P.24 "MEMORY
- Sending a Fax Message -
- -
Immediately
To send a fax message immediately,
use Immediate Transmission. If you
have just set up an original for broad-
casting, Immediate Transmission will
interrupt the current communication.
If there are files queued in addition to
the file being currently sent, your
original is not be sent until the
queued files have been sent.

- Automatic Redial

-
- -
If a fax message could not be trans-
mitted because the line was busy or
an error occurred during transmis-
sion, redialing is done 4 times at 5
minutes intervals (these figures vary
according to which country you are
in).
If redialing fails after four redials, the
machine cancels the transmission and
prints the Transmission Result Report
or Communication Failure Report.
P.29 "Transmission
(Memory Transmission)", P.29 "Com-
munication Failure
"WHEN POWER IS TURNED OFF
OR FAILS"
- - Broadcasting Sequence - -
If you dial several destinations for the
same message (Broadcasting) the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
Broadcasting. For example, if you
Result Report
Report", P.126