Ricoh Aficio 340 System Settings page 273

• When you set an original on the exposure glass, an original narrower than
about 9.25" is scanned as LT/LG size wide. An original wider than 10.83"
is scanned as DLT size wide. Normally, lengths up to a maximum of 17"
can be scanned (this figure varies slightly depending on the type of origi-
nal). If you select Irregular Scan Area, lengths up to 17" are possible.
Length
width
"9.57
"10.55
- Maximum Scan Area - - -
Memory Transmission/Immediate Transmission
• From the Document Feeder (ADF): 297
• From the exposure glass : 297
If the Machine Cannot Detect the Size of Your Original
If the machine cannot detect the original size, the following display is shown:
If this happens, carry out the following steps.
A
Remove the original and replace it on the exposure glass. Press the { { { { Start} } } }
key to scan the original again. If the machine still cannot detect the original
size, the following display is shown:
B
Press the < < and >
< <
again.
"9.80 "9.80 "10.79
not detected LTL
LTK DLTL
432 mm (W
> keys to switch the scan size and press the { { { { Start} } } } key
> >
ACCEPTABLE TYPES OF ORIGINALS
"10.79 "12.44
LTL
DLTL
432 mm (W L)
L)
"12.44
LGL
DLTL
17
1